Cura generated code on CR-10; heats only bed and not nozzle; doesn

Using Cura, I select my printer, CR-10 (1.1.6), the correct flavor, Merlin, verify that I have a temperature of 205 for the nozzle and 60 for the bed, and slice the file and save as gcode. When I attempt to print, the nozzle will heat correctly, but the temperature set point for the bed remains a

getting ready to throw this thing away. I can't seem to get it to do anything right : r/3Dprinting

Just won't hit those nozzle temp targets from cura to start the print. Lower the temp with print tune screen and it starts up in 30 seconds or so. Bought a new

Just installed BL Touch. why is this print warping so bad? room temp 71 hot end 210 bed 50 speed 60 flow 100% : r/CR10

Creality CR-10 3D Printer Official User Group

600 MM/S FAST PRINTING: Creality CR-10SE 3D Printers high-printing speed can reduce production time and you can produce objects in less time, ideal

Creality CR-10 SE 600mm/s High Speed 3D Printer CR Touch Auto Leveling 300℃ Hardened Steel Nozzle 4.3-Inch Touch Screen X and Y-Axis Precision Guide

Creality CR series official user group

creality ender 3 - Cura variables and initial G-code commands - 3D Printing Stack Exchange

Best Cura Settings & Profile for CR-10 Smart Pro – Tested!

4.11 adds unknown bed start code - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Creality CR-10 V2 Review — HackSpace magazine